HB-5969, As Passed Senate, July 6, 2004
SENATE SUBSTITUTE FOR
HOUSE BILL NO. 5969
A bill to amend 1990 PA 187, entitled
"The pupil transportation act,"
by amending sections 15, 17, 19, and 55 (MCL 257.1815, 257.1817,
257.1819, and 257.1855), sections 17, 19, and 55 as amended by
2000 PA 49.
THE PEOPLE OF THE STATE OF MICHIGAN ENACT:
1 Sec. 15. (1) A
school bus shall be equipped with front
2 turn signal lights as
provided by the manufacturer and approved
3 by the department of
state police. These signals shall be
4 independent units equipped
with a 4-way hazard warning switch to
5 cause simultaneous
flashing of turn signal lamps when needed as a
6 vehicular traffic
hazard warning. (2) The location,
number, and
7 color of all exterior lamps and signals on a school bus shall be
8 in conformance with current United States department of
9 transportation, federal
motor carrier vehicle safety
1 regulations , and
with this act where applicable found in 49
2 CFR part 571 and in section 698 of the Michigan vehicle code,
3 1949 PA 300, MCL 257.698.
4 (3) Tail lamps
and signals on a school bus shall be
5 positioned as follows:
6 (a) Two red 7-inch
diameter combination stoptail lamps shall
7 be mounted on the rear
of the school bus at a height of not less
8 than 15 inches or more
than 72 inches above the surface upon
9 which the unloaded bus
rests, and shall be positioned as far
10 apart as practicable.
11 (b) Turn signals
at the rear of a school bus shall be 7
12 inches in diameter
with amber lens and shall be mounted on the
13 same level and
outboard of the stoptail lamp combination unit.
14 Sec. 17. (1) This section applies to school buses
15 manufactured before October 1, 1990 that have not been
16 retrofitted to meet the requirements of section 19.
17 (2) A school bus shall be equipped with signal lights mounted
18 as high and widely spaced laterally as practicable that are
19 capable of displaying to the front 2 overhead alternately
20 flashing red lights located at the same level and to the rear 2
21 overhead alternately flashing red lights located at the same
22 level. These sealed
beam lights shall have sufficient
23 intensity to be visible from a distance of not less than 500 feet
24 in normal sunlight.
25 (3) Overhead alternately flashing stoplights shall be
26 operated by a manually operated switch and detached from any
27 other instrument on the bus. A flashing light shall not be
1 connected to the brakes or the service door on school buses
2 manufactured before October 1, 1990. A 3-inch black area shall
3 be provided around sealed
beam flasher lamps front and rear.
4 Lamps indicating alternating flashing light operation shall be
5 visible to the driver when in a normal seated position.
6 (4) Signal lights and stoplights under this section shall be
7 in conformance with current United States department of
8 transportation federal motor vehicle safety regulations found in
9 49 CFR part 571.
10 Sec. 19. (1) This section applies to new school buses
11 manufactured on or after October 1, 1990 and to school buses
12 manufactured before October 1, 1990 that are retrofitted to meet
13 the requirements of this section.
14 (2) A school bus shall be equipped with signal lights mounted
15 as high and widely spaced laterally as practicable that are
16 capable of displaying to the front 2 overhead alternately
17 flashing red lights located at the same level and to the rear 2
18 overhead alternately flashing red lights located at the same
19 level.
20 (3) In addition to the 4 red lights described in subsection
21 (2), 4 amber lights shall be installed near each red signal
22 light, at the same level, but closer to the vertical center line
23 of the bus. The system of red and amber signal lights shall be
24 wired so that the amber lights are energized manually, and the
25 red lights are automatically energized, with the amber lights
26 being automatically de-energized, when the bus service door is
27 opened.
1 (4) The area around the lens of each overhead alternately
2 flashing signal light and extending outward approximately 3
3 inches shall be painted black. In installations where there is
4 no flat vertical portion of body immediately surrounding the
5 entire lens of a light, a circular or square band of black
6 approximately 3 inches wide, immediately below and to both sides
7 of a lens, shall be painted on the body or roof area against
8 which the signal light is seen from a distance of 500 feet along
9 the axis of the vehicle. Visors or hoods with an appropriate
10 black background to fit their shape and roofcap may also be
11 used. These amber and
red sealed beam lights shall have
12 sufficient intensity to be visible from a distance of not less
13 than 500 feet in normal sunlight. Lights indicating alternately
14 flashing light operation shall be visible to the driver when in a
15 normal seated position.
16 Sec. 55. (1) A school bus driver shall actuate alternately
17 flashing lights only when the school bus is stopped or stopping
18 on a highway or private road for the purpose of receiving or
19 discharging pupils in the manner provided in this act. A school
20 bus driver shall not actuate the alternately flashing lights when
21 operating on a public highway or private road and transporting
22 passengers primarily other than school pupils.
23 (2) The driver of a school bus while operating upon the
24 public highways or private roadways open to the public shall
25 receive or discharge pupils from the bus in the following
26 manner:
27 (a) If pupils are required to cross the roadway, the driver
1 of a school bus equipped with only the alternately flashing
2 overhead red lights in accordance with section 17 shall activate
3 the alternately flashing overhead red lights not less than 200
4 feet before the stop,
stop the school bus as far to the right
5 side of on the roadway or private road as possible
to provide
6 for the safety of the pupils being boarded or discharged, and
7 continue to activate the alternately flashing overhead red lights
8 while receiving or discharging pupils. The bus shall stop in the
9 extreme right-hand lane when boarding or discharging pupils.
10 Before resuming motion, the driver shall deactivate these lights
11 and allow congested traffic to disperse where practicable. The
12 deactivation of these lights is the signal for stopped traffic to
13 proceed.
14 (b) If the pupils are required to cross the roadway, the
15 driver of a school bus equipped with red and amber alternately
16 flashing overhead lights in accordance with section 19 shall
17 activate the alternately flashing overhead amber lights not less
18 than 200 feet before the
stop, stop the bus as far to the right
19 side of on the roadway or private road as is
possible to
20 provide for the safety of the pupils being boarded or discharged,
21 deactivate the alternately flashing overhead amber lights, and
22 activate the alternately flashing overhead red lights while
23 receiving or discharging pupils. The bus shall stop in the
24 extreme right-hand lane for the purpose of boarding or
25 discharging pupils. Before resuming motion, the driver shall
26 deactivate these lights and allow congested traffic to disperse
27 where practicable. The deactivation of these lights is the
1 signal for stopped traffic to proceed.
2 (c) If the pupils are not required to cross the roadway, the
3 driver of a school bus equipped with only the alternately
4 flashing overhead red lights in accordance with section 17 shall
5 activate the alternately flashing overhead red lights not less
6 than 200 feet before the stop, stop the bus as far off the
7 roadway or private road as practicable to provide for the safety
8 of the pupils being boarded or discharged, and continue to
9 activate the alternately flashing overhead red lights while
10 receiving or discharging pupils. Before resuming motion, the
11 driver shall deactivate these lights and allow congested traffic
12 to disperse where practicable. The deactivation of these lights
13 is the signal for stopped traffic to proceed.
14 (d) If the pupils are not required to cross the roadway, the
15 driver of a school bus equipped with red and amber alternately
16 flashing overhead lights in accordance with section 19 shall
17 activate the alternately flashing overhead amber lights not less
18 than 200 feet before the stop, stop the bus as far off the
19 roadway or private road as practicable to provide for the safety
20 of the pupils being boarded or discharged, deactivate the
21 alternately flashing overhead amber lights, and activate the
22 alternately flashing overhead red lights while receiving or
23 discharging pupils. Before resuming motion, the driver shall
24 deactivate these lights and allow congested traffic to disperse
25 where practicable. The deactivation of these lights is the
26 signal for stopped traffic to proceed.
27 (e) (c) If
the pupils are not required to cross the roadway
1 and where the road has adequate width for the school bus to be
2 pulled to the far right of the roadway or private road allowing
3 traffic to flow and to provide for the safety of pupils being
4 boarded or discharged,
the driver may shall activate the hazard
5 warning lights not
less than 200 feet before the stop and
6 continue to display the lights until the process of receiving or
7 discharging passengers has been completed if the lawful speed
8 limit is 35 45
miles per hour or less. Before resuming motion,
9 the driver shall deactivate these lights. The driver of a school
10 bus shall only use this procedure at stops where the school
11 administrator or person or entity under contract with a school to
12 provide pupil transportation services has approved its use. If
13 this hazard warning light option is not used, the driver shall
14 use the appropriate
procedure in subdivision (a), or (b), (c),
15 or (d) as if pupils were required to cross the roadway.
16 (f) (d) Except
as provided in subdivision (c) (e), if the
17 pupils are not required to cross the roadway and where the bus
18 may be pulled off the roadway or private road or where the road
19 has adequate width for the school bus to be pulled off to the far
20 right of the roadway or private road leaving the normal traffic
21 flow unobstructed and to provide for the safety of pupils being
22 boarded or discharged,
the driver may shall activate the hazard
23 warning lights not
less than 200 feet before the stop and
24 continue to display the lights until the process of receiving or
25 discharging passengers has been completed. Before resuming
26 motion, the driver shall deactivate these lights. The driver of
27 a school bus shall only use this procedure at stops where the
1 school administrator or entity under contract with a school to
2 provide pupil transportation services has approved its use. If
3 this hazard warning light option is not used, the driver shall
4 use the appropriate
procedure in subdivision (a), or (b), (c),
5 or (d) as if pupils were required to cross the roadway.
6 (g) (e) The
distance of not less than 200 feet required for
7 light activation by this subsection shall be measured on the
8 roadway or private road on which the stop is made for receiving
9 or discharging pupils.
10 (3) Pupils crossing the roadway upon being discharged from a
11 school bus shall cross in front of the stopped school bus. If a
12 school district authorizes its school bus drivers to signal
13 pupils to cross in front of the stopped school bus, the signal
14 shall be uniform throughout the school district.
15 (4) The driver of a school bus shall not stop the bus for the
16 purpose of receiving or discharging pupils in the following
17 instances:
18 (a) Within 200 feet
of a public highway or private roadway
19 intersection unless the stop is approved by the school
20 administrator or entity under contract with a school to provide
21 pupil transportation services.
22 (b) Upon a limited access highway or freeway, or upon any
23 other highway or roadway that has been divided into 2 roadways by
24 leaving an intervening space, a physical barrier, or clearly
25 divided sections so constructed as to impede vehicular traffic if
26 the pupils are required
to cross the highway or roadway.
27 (c) Upon a highway
or roadway constructed or marked to
1 permit 3 or more separate lanes of vehicular traffic in either
2 direction if the pupils
are required to cross the highway or
3 roadway.
4 (5) The driver of a school bus when using the alternately
5 flashing overhead red lights shall not stop the bus on any
6 highway or roadway for the purpose of receiving or discharging
7 pupils under the following conditions:
8 (a) If the lawful speed limit is more than 35 miles per hour
9 and the stopped bus is not clearly and continuously visible to
10 approaching vehicles on that highway or roadway for at least 400
11 feet. When the distance from the stopped bus to the end of the
12 highway or roadway is less than 400 feet, clear and continuous
13 visibility must be available from the bus to the end of the
14 highway or roadway.
15 (b) If the lawful speed limit is 35 miles per hour or less
16 and the stopped bus is not clearly and continuously visible to
17 approaching vehicles on that highway or roadway, for at least 200
18 feet. When the distance from the stopped bus to the end of the
19 highway or roadway is less than 200 feet, clear and continuous
20 visibility must be available from the bus to the end of the
21 highway or roadway.
22 (c) Within 50 feet of an intersection if the intersection is
23 controlled by a traffic stop
and go control signal.
24 (6) A school may provide instruction on proper school bus
25 etiquette which may include, but not be limited to, boarding and
26 leaving the bus, evacuation of the bus in an emergency, and road
27 crossing procedures and the correct hand signal in the district,
1 if any. If a school uses school bus drivers for this
2 instruction, the state board may reimburse the school for this
3 training.
4 (7) For the purpose of this section, "required to cross the
5 highway or roadway" does not include crossing the highway
or
6 roadway with the assistance of a traffic control signal, or with
7 the assistance of a school crossing guard as defined in
8 section 57b of the Michigan vehicle code, 1949 PA 300, MCL
9 257.57b, and applies only
to the highway or roadway on which
10 the stop is being made.